Gutter Repair & Replacement in Kennesaw, GA
Kennesaw gutter work is mostly about capacity: runs and downspouts sized for the roof they actually drain. Every job comes with a written number that does not move.

Sizing gutters for the roof
The common problems on Kennesaw homes are undersized runs, too few downspouts, and discharge too close to the house. The calculation is roof area, pitch, and outlet capacity. We measure it rather than replacing like for like and hoping the original spec was right.
Where the water goes after the downspout
The most commonly skipped part of a gutter job is the last two feet. A downspout that discharges at the base of the wall has moved water from your roof to your foundation, which is not a solution. Extensions, splash blocks or a buried run to daylight cost very little relative to the gutters themselves and determine whether the job was worth doing. Gutter work does not require a building permit from the City of Kennesaw, which permits online only for work that does — worth knowing if the job grows to include structural repair.
Questions Kennesaw homeowners ask us
Not automatically. We check roof area, pitch and downspout count so the new gutters can actually carry the water, rather than replacing like for like.
Clear of the foundation — extensions, splash blocks or a buried run to daylight. A downspout emptying at the base of the wall has just moved the problem from your roof to your footing.
No. The City of Kennesaw permits building work and does so online only. Gutters alone do not require it, though structural repair discovered during the job would.
Only with your approval, after photographs, and only if the scope genuinely changes — fascia rot being the usual reason. The written number is the number.
Linear footage, size, downspout count, and whether fascia repair is needed. Free inspection, written quote.
