Exterior Painting & Staining in Powder Springs, GA
Cobb summers cook west-facing elevations in Powder Springs. If the existing coating is chalking or peeling at the eaves, we plan the scrape and prime rather than rolling over it. You get a written scope, not a one-line “paint the house.”
West eaves chalk here, and rolling over chalk is how coats slide off
The afternoon sun sits on west walls and on the underside of eaves that have no shade. Chalk is the binder giving up. A fresh coat rolled onto chalk bonds to the powder, and the powder lets go. We scrape, wash the chalk off, prime the bare and the stained wood, and then finish. East walls that are still tight get a different line on the scope. You should be able to read which elevation is a wash-and-coat and which one is a strip.
Inside the city, a color is not a building permit
Powder Springs issues building permits itself. A repaint of sound material is not that filing. The city’s contractor rules for work that does need a permit, including the license and bond language, are on the siding page for this city and on the city’s own site. If a “paint” visit turns into rotten soffit or an open wall, we stop calling it a color job and ask the city before we continue. Until then, the scope is wash, scrape, prime, and finish.
Chalk on the eaves is a binder failure, not a dirty wall
Run a hand under a west eave here and it comes back white. That powder is the old binder, and it has to leave the board before a new film will stay. We do that elevation fully. A north eave that is tight and only dusty gets a wash. Mixing those two into one line is how the bid looks cheap and the west eave peels again. If the peel is wet, not chalky, the water is above the paint. Read roof repair in Powder Springs before you buy a finish for a board that is still taking on rain.
Also in Powder Springs
Siding in Powder Springs · Roof repair · Roof replacement · Exterior painting hub
Questions
Not for a coat on sound material. The city does issue its own building permits. If we open rotten soffit, we stop and ask the city before anyone keeps painting. The license and bond rules for that permitted work are published by the city and spelled out on our Powder Springs siding page.
The white powder is dead binder. Paint sticks to the powder and falls off with it. That eave is washed, scraped, primed, and then finished. A tight east wall is not the same line.
No. How much binder has failed, and whether any board is wet, changes the day. You get a written figure after the visit, not a range on this page.
Yes when you want both. They are written as separate scopes. Water still entering means the roof line comes first.
